SCS Climbing System

With PERI SCS, the loads from the fresh concrete pressure are transferred without formwork through the brackets into the climbing anchors of the previous concreting section.

The SCS Climbing System is predominantly used for single-sided applications, i.e. with non-tied wall formwork. The loads resulting from the fresh concrete pressure are thereby transferred via the brackets into the previous concreting section by climbing anchors. Typical areas of applications for the SCS Climbing System are dams, locks, cooling towers, bunkers and strongroom vaults, pier heads, and tunnels. With very few additional components, the brackets are also suitable for forming with anchored wall formwork.

Large, crane-able climbing units

due to the particularly high load-bearing capacity of the brackets with good utilization of the anchoring

Material-optimized solution

with the same formwork and components for the starter and subsequent standard cycles

Safe, horizontal working areas

through inclinable platforms which can easily be adapted to suit inclined structural elements

Cost-effective also for two-sided applications

through a minimum of additional components for a high level of material utilization and reduced logistical requirements

Technical Details

• Support structure for supporting non-tied, single-sided wall formwork
• With the SCS system, two bracket units together with one PERI wall formwork section form a cranemovable platform unit.
• Optionally, VARIO GT 24 Girder Wall Formwork as well as TRIO or MAXIMO Panel Formwork can be used.
• The SCS Climbing System has been optimized for a concreting height of 3.00 m (vertical applications) or 2.50 m (forward-inclined applications).
• With only a minimum of additional components, the use of anchored formwork is also possible for walls up to 6.00 m high.
• The addition of a finishing platform is possible
• Separate adaptable working platform for use on inclined structures; concreting and finishing media can be tilted by ±15° und ±30°