PEP Ergo Slab Props

The galvanized tubular steel slab prop from PERI with up to 50 kN load-bearing capacity

PEP Ergo Props are mainly used for supporting slab formwork. Numerous practical features ensure fast and safe handling – this includes, for example, the Adjusting Nut indicating the direction or the ergonomic G-Hook which does not jam.

Galvanization guarantees a long service life. However, if a prop does get damaged during the tough everyday working operations on the job site, the inner and outer tubes can be replaced separately.

PERI PEP Ergo Props are characterized by a further increase in load-bearing capacity and numerous trend-setting detailed solutions with low dead weight.

The capacity factor – defined as the load-bearing capacity to prop weight ratio – can reach up to 70 % above the values of comparable slab props. PERI PEP Ergo Props fully comply with Load Class B, D, and E of EN 1065. The maximum load-bearing capacity is 50 kN.

The complete galvanization of all surfaces guarantees a long service life.

Load-bearing capacity far beyond the norm
Prop load up to 50 kN – with a comparatively low dead weight
(PEP Ergo E-300+: G = 19.3 kg; max. F = 50.4 kN)

Quickly adjusted
The 12 cm long adjustment range eliminates frequent re-positioning whilst the measuring scale on the inner tube accelerates length pre-adjustments

Simple connections
Prop heads can be attached to both the inner and outer tubes

Trendsetting adjusting nut
The form of the lowering nut dictates the direction of lowering the load while the captive handgrip allows easy adjustment

Product variants

Further technical details

• Fully galvanized tubular steel slab props for transferring vertical loads
• Maximum prop load: 50 kN
• Building authority approved (PEP Ergo) | type-tested (PEP 20, PEP 30)
• Prop lengths: up to 1.50 m | 2.50 m | 3.00 m | 3.50 m | 4.00 m | 5.00 m
• The generous adjustment range of 12 cm
• Total length stamped on an inner tube in 10-cm increments to the pegging holes
• Tripods or frames available as installation anti-crush-crush device with a safety clearance of protect section against injury
• Prop type and length can be read directly from the outside on the end plate, also on stacks of props